How to deal with the details before the basic knowledge of CNC machining center?

CNC machining center is composed of mechanical equipment and numerical control system is suitable for processing complex parts of high efficiency automatic machine tool. Although CNC processing can improve the production efficiency of the whole processing enterprise, improve the quality of the workpiece, but we must pay attention to the details before processing, what are the specific?

The work efficiency of CNC machining center is very high, and the preparation work before starting is essential. Every day to operate the processing center operation of friends may not understand a set of standard and complete processing center startup preparation.

Before operating the machine, check whether the reference position of the workpiece is consistent with the position of the drawing after receiving the program sheet. Verify that the program is consistent with the drawing requirements, if any problems, must be resolved and discussed with the programmer and production staff. Do not start processing in doubt.

According to the material and size of the workpiece, judge the programmer to open coarse or light knife program selection of tools to be reasonable, if the CNC machining center tool application is not reasonable, should immediately notify the programmer to make the corresponding changes, in order to improve the processing efficiency and workpiece processing accuracy.

When clamping the workpiece, pay attention to the position of the fastener and the extension length of the nut bolt on the press plate is moderate, in addition, the screw can not be the top and bottom of the lock Angle fastener.

Before the tool head is installed on the machine, the matching position of the taper should be cleaned with a clean cloth. The corresponding position of the tool sleeve should also be cleaned, so as to avoid the impact of iron scraps on the matching surface and damage to the CNC machining center.

CNC processing is important for the first knife, because if careful operation and check can be known that the length of the knife, the knife diameter, program, speed and so on is wrong, to avoid damage to the workpiece, tool and machining center.

A qualified CNC processing cannot be separated from timely communication with colleagues and grasp the key points at the end of the small end, only in this way can the performance of CNC machining center be more accurate. In order to better realize CNC machining.